Pressing in trailing arm shafts
|
Pressing in trailing arm shafts
|
03-03-2015, 12:46 AM
When I dismantled my beam I stupidly didn't note down many measurements. I need to press in the new trailing arm shafts and assumed there would be a step on the shaft to push it in to. There isn't though so I need to know how far in to press it. I assume it just goes in so that it is flush with the other side?
Thanks, Ben ![[Image: 20120704_212316.jpg]](http://i789.photobucket.com/albums/yy175/DanHargrave/20120704_212316.jpg) |
|
« Next Oldest | Next Newest »
|
| Messages In This Thread |
|
Pressing in trailing arm shafts - by Ben - 03-03-2015, 12:46 AM
RE: Pressing in trailing arm shafts - by Ben - 03-03-2015, 01:59 AM
RE: Pressing in trailing arm shafts - by welshpug - 03-03-2015, 03:43 AM
RE: Pressing in trailing arm shafts - by pug306driver - 03-03-2015, 10:39 AM
RE: Pressing in trailing arm shafts - by powerandtorque - 03-03-2015, 11:20 AM
RE: Pressing in trailing arm shafts - by Ben - 03-03-2015, 05:30 PM
|
| Possibly Related Threads… | |||||
| Thread | Author | Replies | Views | Last Post | |
| 205 drive shafts | Doseph | 5 | 2,523 |
05-03-2017, 08:32 PM Last Post: Doseph |
|
| Do BE drive shafts fit MA hubs | Dum-Dum | 3 | 1,441 |
13-06-2015, 11:38 PM Last Post: Rippthrough |
|
| Do phase 3 1.4 petrol shafts and hubs fit hdi? | maguire1992 | 5 | 2,476 |
18-02-2014, 09:07 AM Last Post: Mattcheese31 |
|
