2.2 Dimma Hdi

[Jimmer021]

Im not really sure who to ask, does anyone still do mapping for vnts on hdis? apparently tb isnt anymore so havent been able to get hold of him.

So far I have changed 3 vacuum selenoids and the map sensor, still got nothing, although changing the map sensor reduced the smoke abit. I tried adjusting the selonoid again the other day but just blew a boost hose straight off and didnt have any tools with me at the time.

I spoke to pro steve he said to try adjusting the length of the arm on the turbo, but if i block the atmospheric port on the selenoid i get full travel on the arm, so surely it has to be a fault within the ecu as its not adjusting on its own?

Also i think i need a new heater motor, how easy are they to replace?

---

You wont need to change the fuel tank, fuel pump, fuel lines, sub frame, wiring (other than the appropriate plug and play engine loom).

Clocks, engine, box, exhaust down pipe, engine loom and that should be it. Driveshafts might be the same.


Dont know about swapping the clutch back to cable, might need a new pedal box depending on how its been modified.

The sub frame has been modified with what looks like a sledge hammer for the 2.2 box to clear, so thats why i would change that.

The bulkhead has been modified to accept the master cylinder, although im not sure to what extend, from what i can see there is some weld around where it comes through