fmic piping

[philpemberton94]

Just wondering how everyone routes their front mount pipes on the drivers side, i bought a kit of a 306 but can't get it to line up properly!

Any help appreciated,
Phil

[Mattcheese31]

Most people route both pipes round passenger side of the rad, that or remove washer bottle and go round there

[silverzx]

[philpemberton94]

Was thinking i might have to go to the passenger side, will have to get a few more pipes!

[eskimogod]

Can always get a twin pass cooler.

Silverzx that's a damn tidy install!

[silverzx]

Was thinking i might have to go to the passenger side, will have to get a few more pipes!

Meh, I find buying a "kit" with a few extra silicone pipes chucked in usually does the trick!

Can always get a twin pass cooler.

Silverzx that's a damn tidy install!

A decent twin pass is £130, I personally would rather cut a hole and route through the washer bottle or do the "pikey" twin pass like I have with this install.

Cheers mate, you get good at it after doing it a few times.

[Jtrigga]

Here's mine on my old dturbo

[silverzx]

Here's mine on my old dturbo

Not a personal dig at you but I hate those setups because:

A) It uses the standard shitty 2" pipe from turbo upward and I always struggle to fit a 2" pipe in it properly, it usually ends up popping out etc.

B) It goes over the radiator, this usually ends in knocking, fowling of the radiator and ultimately damage.