Aerial Seal

[RetroPug]

Hello,

I've been told by a peugeot dealer that 306 aerials do not have a seal?
I can't find on on service box either, however I have heard of others buying these seals from peugeot.

As a last resort I'll just silicone it up but for the sake of a few quid I'd rather do it properly, so does anyone know a part number for an aerial seal for a Ph.1 306? Or a print-out from servicebox ideally?

Thanks.

[rocker8742]

Never seen a specific seal the unit itself should seal enough, changed mine a while back and never had any issues x

[cully]

i cut a thin rubber gasket for mine as it was leaking, it works, no leaks yet

[Danny2009]

tiger seal has always worked for me

[RetroPug]

Never seen a specific seal the unit itself should seal enough, changed mine a while back and never had any issues x

So you got a new aerial base basically?
If they're not too expensive I'll do this and then silicone it up for good measure.

[Toms306]

http://public.servicebox.peugeot.com/doc...refaff=N3G 6 65K01A&noFct=1

Doesn't seem to be a gasket for them.

[Mattcheese31]

there is no gasket, just make sure the surfaces are clean and don't under or over tighten it . . .

[Eeyore]

Nope there may be a thin bit of rubber but im pretty sure you just need to do the nut up tight enough and it seals anyway.

[RetroPug]

Yeah I've looked at service box myself and with a peugeot dealer and it does appear that there is no seal.
My current one is leaking a tiny bit, might remove it, reseat it and then silicone.

Thanks!

[rocker8742]

Never seen a specific seal the unit itself should seal enough, changed mine a while back and never had any issues x

So you got a new aerial base basically?
If they're not too expensive I'll do this and then silicone it up for good measure.

Mine was only leaking as I snapped the old one off accidentally

New one was £6 ish on eBay

[RetroPug]

Thanks!