08-07-2015, 06:43 AM
(08-07-2015, 06:35 AM)Piggy Wrote: ph1 heater controls rarely fail tbh, they are very basic by their nature.
my bet would be resistor died and potentially a dying blow motor which is overheating the resistor pack
Had the motor out last night, and actually looked quiet fresh, was expecting all sorts of shit to fall out of it and it literally needed a quick clean (greased the bearings while I was there) and there was pretty much no play in it too :S
where is the resistor pack in a ph1? and is there any to test it?