Andyyy's 1.9 DT 205 Cherry Red VNT

[andyyy]

Well I put all the fuses back in and the rev counter still isn't working. Tried swapping the red and white cable which made no odds. Will check the earth and 12v feed when I can figure out where iv left my multimeter.

In over news the new gearbox is working and iv ran new copper brake lines. Got to tidy up a few wires in the engine bay and get a longer speedo cable as the exhaust is in the way of the old routing. Then I should be able to move on to finishing the paint on the roof as I'm still not happy with it and redo the rear quarter again.

Still have to find a windscreen as ever time I get close to one it gets smashed! Might even have to buy a brand new one.

Also need to finish off the exhaust parts are on there way but taking there sweet time to arrive.

Once all the painting is done I'll be able to put all the rubbers / windows back in and the plastic gti body kit etc and hopefully be able to get it back on the road , really starting to miss driving this!

Essay over !

---

I had the same issue on mine and bought a new sensor but didnt work.

If you look at the clocks from the driving seat position there is 2 earth plugs beside them make sure they are plugged in as mine werent causing the gauge not to work if not i can send you the bramd new sensor i used as its tested and working

Thanks I'll check the Earths I have a brand new sensor, not that means it works! If I can't get it going with what iv got I'll take you up on that offer. Thanks for the advice much appreciated.

---

Check you have a 12v feed to the Rev counter plug

---

Pin 3 from memory

Paul any chance you know the full pin out ? I assume 2 pins go to the sensor and the other two are live and earth ? 

Also anyone know how to test the sensor I have access to oscilloscope if nessasary?