11-01-2014, 05:10 PM
Its a sprinter intercooler, they are cheap brand new (like sub £50). The passenger side goes between the rad an chassis leg prefectly, the driver side I had to cut the bottom corner off the vertical part of the chassis leg and remove the plastic splash guard. Not sure if I'm going to be able to refit the washer bottle there, if not its not a big issue.
Its only held on with 1 bolt but its first to pipes off it are on and clearance is fine.
In 4 hours today I stripped the front end (PITA considering the previous owner had done everything up stupidly tight), removed all the air con and the fans, removed a PAS pipe bracket, ran a die over one of the studs on the chassis, hammered a few bits straight or flat and did a very delicate cutting job with a 9" grinder.
Hopefully gonna pipe it up tomorrow.
Its only held on with 1 bolt but its first to pipes off it are on and clearance is fine.
In 4 hours today I stripped the front end (PITA considering the previous owner had done everything up stupidly tight), removed all the air con and the fans, removed a PAS pipe bracket, ran a die over one of the studs on the chassis, hammered a few bits straight or flat and did a very delicate cutting job with a 9" grinder.
Hopefully gonna pipe it up tomorrow.
