FOR SALE: Fully Custom Peugeot HDi Remaps, £50!

[jammapic]

Hi,

So, the sun is out and we're all enjoying our cars... I thought I'd do another HDi mapping deal so we can all go that little bit faster! :-)

As before with the last deal I ran, ANY HDi map, stage 1, stage 1+, stage 2, stage 2+, hard cut limiters, bespoke Stage 3 maps, 1800bar rail sensor mods etc etc etc, all just £50 if ordered before the end of the month.

Can do this as a remote email file service, or flash it here at my premises in Lancashire for a small fee.

Also, I'm happy to discuss more with people if they are after specifics....

Rough power outputs (depending on mods) are:

Stage 1 - 125hp / 220lbft.............. Can be run on a total stock car.
Stage 1+ - 135hp / 240lbft............ Requires decat / exhaust
Stage 2 - 155hp / 280lbft.............. Requires intercooler and ideally upgraded clutch
Stage 2+ - 170hp / 300lbft............ WILL require clutch / exhaust / decat / intercooler
Stage 3 - 200hp+ / 350lbft............ Requires bigger turbo.

james@nosmokenopoke.com, 07769165138.

Thanks,

JP

[deggerz]

Had JP do my father's 406 hdi and have to say now goes like stink, well recommended

[Pete]

Seimens ecus?

[jammapic]

If you send me them and can leave it with me a couple of days, sure.

[Pete]

Good do I'll see if I can sort something trouble is I need the van daily

[Damo]

Looking at a stage 1+ will pm or email as soon as i decide

[Chris306]

Looking at the stage 2 map, how
Would I pay for it mate??

[jammapic]

Paypal gift is my preferred method, but can also take bank transfer, credit / debit card payment over the phone or Chip & PIN here at my place.

JP

[Chris306]

Paypal gift is my preferred method, but can also take bank transfer, credit / debit card payment over the phone or Chip & PIN here at my place.

JP

Pm'ed you mate

[Kezzieboy]

Just out of interest, you capable of doing a 1.4 HDi? What do you think you could get from it with no supporting mods?

[sweeney1987]

out of interest can you map vnts on 306 hdis?

[jammapic]

Yes I can do 1.4 HDi. Can only really gain about 20/25hp on them due to the lack of capacity!!! :-)

Yep, do do VNT maps on HDi's assuming you can get the hardware side setup correctly.

JP

[jammapic]

That's 2 done tonight, a stage 1+ and a normal stage 1.... and all from the comfort of a hotel room! :-) enjoy lads!

JP

[Connor]

I will have one, soon as I sort my boost gauge and get paid

[Alan_M]

Should be contacting you shortly for one of these. But, what exactly do you mean by exhaust/DeCat for a Stage 1+?

I was under the impression the centre box wasn't restrictive (hence, why it's used as a backbox) so I've kept it and bought a Sportex backbox. I've a DeCat pipe too which will be fitted after the MOT. It's been De-EGR'd via blanking plate and it's had refurbed 076 injectors fitted. Will this be OK for a Stage 1+?

[jammapic]

That is perfect, and almost exactly what I meant!!

JP

[Ben Jay]

I know it's not a pug but can you remap a 2.2 Honda civic diesel?

[n0v0s]

The 2.2cdti are edc16, I forget the exact variant. Not doubt JP could crack it if he hasn't already done so.

If you're up for the 'challenge', my 330d is running a 3" decat and pretty much straight through exhaust.. On a standard map

[jammapic]

I know it's not a pug but can you remap a 2.2 Honda civic diesel?

funnily enough I did one of those the other week - it absolutely flew!!!

Also, BMW no issue...

JP

[1616six]

So you'd be willing to have a go at my 320d 177bhp? N47 engine & what sort of gains do you expect?

I'll be oop north in September sometime..

[Ben Jay]

I know it's not a pug but can you remap a 2.2 Honda civic diesel?

funnily enough I did one of those the other week - it absolutely flew!!!

Also, BMW no issue...

JP

How much? It's for a mate who wants more oomph!

[jammapic]

So you'd be willing to have a go at my 320d 177bhp? N47 engine & what sort of gains do you expect?

I'll be oop north in September sometime..

Did one in a 1 series, gained about 30/40hp. Well into the 200's anyway.

I know it's not a pug but can you remap a 2.2 Honda civic diesel?

funnily enough I did one of those the other week - it absolutely flew!!!

Also, BMW no issue...

JP

How much? It's for a mate who wants more oomph!

PM me mate, we'll sort it.

[Carlos182]

Grande Punto 1.9 derv? Friend is looking into getting his mapped

[jammapic]

Yep, it's a GM engine, same as Vectra etc etc

[jammapic]

Hi,

Just to clear something up...

I have been asked a number of times now if the map has to be DONE by the end of the month to get this deal, or just paid for. The answer is the latter.

So long as you've paid for it, I will honor the job at any point you are ready for it in the future. This seems to be because people are ordering MPPS cables and not sure when they are arriving, or are paying for the map now so when they have done certain mods to the car in the coming weeks they can still get the map for that price.

Cheers,

JP

[devils_fuel]

JP can you do a 2007 407, I've no idea what ecu it has.

The car is a little flat at low revs so I was hoping for a little more everyday poke but also tuned for economy, is that possible?

Can you also map out the DPF?

[jammapic]

What engine is in the 407? I suspect yes I can, if you can read it then yes I can map it! :-)

Also, DPF is no problem!

JP

[Mitch1793]

ahhh! i only bought a HDi Tuning map 2 weeks ago!

[devils_fuel]

What engine is in the 407? I suspect yes I can, if you can read it then yes I can map it! :-)

Also, DPF is no problem!

JP

It has the 16valve 136bhp 2.0 hdi, Siemens ecu I guess?

Where are you based as I guess I'd have to drive to you?

[jammapic]

That particular one can normally be read with galletto actually. Read it, and send me the file. Last one I did made 180hp!!

JP