106 1.5D TURBO!! (again)

[Martin306]

Decided to take the engine out, horrendous noise coming from the gearbox. Definitely input line so either clutch or the gearbox input shaft. Rather than piss about I removed the whole engine. Did the timing belt, treated some rust and fitted a lighter flywheel and a spare gearbox.

I was tempted to fit the VE pump, but couldn't be arsed cutting my slam panel and moving my radiator. So sticking with the trusty old Type 070 DPC pump

Engine ready to come out:


Engine coming out:


Engine ready to go in:


Didn't have the right colour of paint, but I had loads of blue. 

In desperate need of rigging up a tacho. Not sure of the best way to go about this, it already has a 3 pin flywheel sensor.

I did find an old picaxe so I guess I could use that to control the signal going to a generic tacho. If I can remember how to work it, it's ooooold

Unless anyone has any dirt cheap ebay links?

That is all!