Today was raising the rear beam! Was a lot harder then expected as it appears to of been done the notch method in the past and the drivers side was seized solid on both bars, we had to to take the trailing arm off and get it in a press, put ten tonne of pressure on it and also heat it up at the same time!
I think it looks loads better, raised it about 4cm
Anyway pictures:
Before:
During:
After:
I think it looks loads better, and its a much better drive with it higher
Thanks to Mitch for helping!
I think it looks loads better, raised it about 4cm
Anyway pictures:
Before:
During:
After:
I think it looks loads better, and its a much better drive with it higher
Thanks to Mitch for helping!