Stud conversion sizes..

[Wor Jimmy]

Reet i need some sizes off you guys/girls!



I am making some wheel spacers with a stud conversion. to a different PCD to stock.
what i need is the size between the back mating face of the wheel and the front under the nut. (See pic Paint ) or even if some one can measure an already done conversion and tell me then length of the protruding thread from the back face off the wheel.
Thanks in advance peeps.

[kentiiboii]

The stud had to be I have 15mm spacers and needed 70mm studs.

[Dum-Dum]

It is a different size on every wheel, it isn't a standard size.

You need to go into the hub and any wheel nut by 10mm (thats 8 turns on the standard thread)

[Wor Jimmy]

It is a different size on every wheel, it isn't a standard size.

You need to go into the hub and any wheel nut by 10mm (thats 8 turns on the standard thread)

Balls.. Heres me thinking this would be easy haha.
might just make them over length and part off the extra as needed.

[kentiiboii]

I know most places do them in 50,60,80mm that way you can work out your self which you need.

[Wor Jimmy]

I know most places do them in 50,60,80mm that way you can work out your self which you need.

60 is what i think i will need. Might just order a few and check.