intercooler gasket

[pauldiesel]

I've got a leaky leak off pipe on one of my injectors and was hoping to change it over, I know I need to take the intercooler off to get to it but will I need a new gasket when putting it back on or will the old one do?

[n0v0s]

I put on a new gasket, and must have reused it near 30/40 times. I used a bit of silicon to hold it in place due to expansion. Sealed ok at 35psi+ .. Should be fine if yours is in gd condition. Less than a fiver new.

[Ruan]

I put on a new gasket, and must have reused it near 30/40 times. I used a bit of silicon to hold it in place due to expansion. Sealed ok at 35psi+ .. Should be fine if yours is in gd condition. Less than a fiver new.

Lolz, this...

The amount of times I've reused D seals and steel inlet gaskets...

Worst case scenario if it falls out and you can't get it back in due to expansion - cut it, take a little chunk out and superglue back together... Works every time for me.

[Jonny81191]

AFAIK you can't get them from Peugeot any more so looks like you'll have to reuse it

[Dicky]

I put on a new gasket, and must have reused it near 30/40 times. I used a bit of silicon to hold it in place due to expansion. Sealed ok at 35psi+ .. Should be fine if yours is in gd condition. Less than a fiver new.

Lolz, this...

The amount of times I've reused D seals and steel inlet gaskets...

Worst case scenario if it falls out and you can't get it back in due to expansion - cut it, take a little chunk out and superglue back together... Works every time for me.

I do this..

[r3k1355]

Still sell them on eBay.

[pauldiesel]

Cheers everyone, I'll whip it off tomorrow and have a look, not sure what it's gonna look like as the car has over 200 k on the clock, it's probably well knackered

[aggyj17]

I just ordered a couple from peugeot so you can still get them

[Jonny81191]

I just ordered a couple from peugeot so you can still get them

Must just be my local place being gay, I'll give them some abuse next time I go in there.