masked lights

[neilz85]

i`m thinking of doing mine, but because its silver, wheather i should leave it.
i have seen someone on here with them in black, on a silver car, but cant find the pics.
was wondering if someone could point me in the direction

[Jonny81191]

Go for it! Do the badge as well



They're in graphite grey, if you look in my project thread later on, I've just finished doing mine black, I'll chuck up a picture when I've fitted them.

[kernow_joe]

they can be fun to seperate if they are valeo ones

[puglove]

they can be fun to seperate if they are valeo ones

Noooo they are ok! Oven at 120 for 10 mins screw driver in the bottom to leaver it out. Get you fingers in there and pull the lens of gentaly.

I done another set last night. Took me the whole of 2mins per light once they were up to temp

[wonkey18]

i was going to do mine in purple to match my colour scheme, do you think it will be to much?

[Scott]

I've not seen the rest of the car yet, but I've seen purple masks with the lower half of the grille also being purple. Wasn't so keen on the grille, but the lights looked good. That was on a manstone

[puglove]

i was going to do mine in purple to match my colour scheme, do you think it will be to much?

I recon it could be pretty epic

[WiNgNuTz]

Noooo they are ok! Oven at 120 for 10 mins screw driver in the bottom to leaver it out. Get you fingers in there and pull the lens of gentaly.

I done another set last night. Took me the whole of 2mins per light once they were up to temp

How do you go about putting them back together/resealing them? Might do my own if I can acquire a decent set from the scrappy.

[spike2002]

Mine are purple on silver

Pics of mine and someone elses car in this thread

http://306oc.co.uk/forum/forum-12-page-5.html

[puglove]

Noooo they are ok! Oven at 120 for 10 mins screw driver in the bottom to leaver it out. Get you fingers in there and pull the lens of gentaly.

I done another set last night. Took me the whole of 2mins per light once they were up to temp

How do you go about putting them back together/resealing them? Might do my own if I can acquire a decent set from the scrappy.

Clean the joint out. Wack a shed load of black/clear mastic in there. Put then back togeter with 2 bungy straps round it to hold it togeter whilst it drys. Then us a rag with whie spirt to clean off excess and tidy it up. Simples. Warter/air tight and dosnt even look like they have been apart