07-10-2015, 08:40 PM
(This post was last modified: 02-11-2015, 09:43 PM by daveylennon93.)
So bought a Phase 2 Dturbo about 6 months back as a project and it got put on hold until now.
The bodywork isnt great but i want to spray it anyway and its in need of a new engine, but it is clean underneath. Basically no rust(small bits of surface rust).
So the plans over the next while are:
Sort out body and a respray( probly be the last to get done)
Replace engine with a good 1.
Turn into a carvan.
And the parts i have in stock for the build:
2 engines
2 bosch pumps
t2 and k14 turbos.
Front mount and all pipework.
HDI Rods
MLS Head gasket.
ProSport boost gauge.
60mm lowering springs or ta coilovers.
Started rippin the other day and so far have 1 engine dismantled to see what condition its in. Seems good but there are cracks in the precups on the head.
Bit of sanding done
Them bearings look good?
And hers the cracks on the precups and on tge head itself. Dont know if its usable
The bodywork isnt great but i want to spray it anyway and its in need of a new engine, but it is clean underneath. Basically no rust(small bits of surface rust).
So the plans over the next while are:
Sort out body and a respray( probly be the last to get done)
Replace engine with a good 1.
Turn into a carvan.
And the parts i have in stock for the build:
2 engines
2 bosch pumps
t2 and k14 turbos.
Front mount and all pipework.
HDI Rods
MLS Head gasket.
ProSport boost gauge.
60mm lowering springs or ta coilovers.
Started rippin the other day and so far have 1 engine dismantled to see what condition its in. Seems good but there are cracks in the precups on the head.
Bit of sanding done
Them bearings look good?
And hers the cracks on the precups and on tge head itself. Dont know if its usable
HDI D'Turbo Daily Driver ---- XUD D'Turbo Project