10-02-2013, 09:11 AM
Me and friend at work made a fmic adaptor last week . Can offer these at 30 pounds posted if any interest . Not as good as xantia route but can't see any problem with them .
Sheet steel double seam welded. 2.25 inlet boost pipe re off. Thicker base to ensure it clamps down tight. gasket cut from proper gasket paper . Also not shown in pic a bead of weld will be run around the end of intake pipe to stop pipe blowing off. And we have found a better way for compensator take off .the one in pic is not ths best
![[Image: 20130208_142816.jpg]](http://i679.photobucket.com/albums/vv153/jim-bob1991/20130208_142816.jpg)
![[Image: IMG_0811.jpg]](http://i679.photobucket.com/albums/vv153/jim-bob1991/IMG_0811.jpg)
Finished item will be smoothed down and painted. And were Going to rig up a pressure tester and test to around 30 psi. The one in the pic is the first run we will be taking taking more time with any that we sell.
Thanks
Sheet steel double seam welded. 2.25 inlet boost pipe re off. Thicker base to ensure it clamps down tight. gasket cut from proper gasket paper . Also not shown in pic a bead of weld will be run around the end of intake pipe to stop pipe blowing off. And we have found a better way for compensator take off .the one in pic is not ths best
Finished item will be smoothed down and painted. And were Going to rig up a pressure tester and test to around 30 psi. The one in the pic is the first run we will be taking taking more time with any that we sell.
Thanks