Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
WANTED, hints and tips to either bung or replace heater
#5
There should be 2 pipes low down on the front firewall 1 in and 1 out(flow and return) there should be hoses connected to them. Disconnect these and block them off with a couple of short bolts preferably stainless ones with a bit of plumbers PTFE tape wrapped round the threads and jubilee clips over the hose. A hose clamp may help prevent coolant loss when disconnecting. If you don't have one a speed clamp or mole grips should do the job just don't split the hose by clamping too tight put a small bit of cloth round the hose first.
You may want to replace the matrix later in the summer if you use the cabby in winter but put a day aside for it as it can take a while if you've never done one before.
A new matrix can be picked up off fleabay for around £35 delivered.
Oh and don't forget to drain the water by popping the bungs in the footwell from underneath then if you have acces to a wet vac get as much as the remaining moisture out as it will cause rust and horrible smells if left.
See if you can get a load of moisture absorbing silica like you get those little sachets in boxes of trainers or sports bags pull up the rubber door seals and pull the carpet away and pop some in there for a week it so just to make sure. Oh and remember to replace the bungs in the footwells lol.
Reply
Thanks given by:


Messages In This Thread
WANTED, hints and tips to either bung or replace heater - by ash240970 - 28-05-2012, 02:25 PM

Possibly Related Threads…
Thread Author Replies Views Last Post
  Wanted: Resinator bung gti6 sherman306 8 1,823 22-07-2014, 12:34 PM
Last Post: sherman306
  Rear wiper bung! W1ll 8 2,634 17-04-2014, 08:44 PM
Last Post: bigcheez2k3
  Wanted | Heater Matrix hoses zx_volcane 12 4,260 02-03-2014, 12:30 PM
Last Post: Slam Wagon

Forum Jump:


Users browsing this thread: 1 Guest(s)