|
Inlet stud help
|
22-05-2012, 10:22 AM
See I have mixed opinions on this.... when I did matts, it wasnt quick clamped enough on a few of the studs and was pissing at about 24psi... retightening them sorted it... so I would have thought having some missing would be worse.... if you have boost problems then I would get it sorted, but if the gasket is good and there are no boost issues then I wouldnt worry.
![[Image: 22f2b6b2-758b-4c1c-96fb-6fa9c6059b13_zpsf306b56b.jpg]](http://i585.photobucket.com/albums/ss299/Ha11elujaz0rs/22f2b6b2-758b-4c1c-96fb-6fa9c6059b13_zpsf306b56b.jpg)
|
|
« Next Oldest | Next Newest »
|
| Messages In This Thread |
|
Inlet stud help - by Ricky - 08-05-2012, 05:30 PM
Re: Inlet stud help - by Chris - 08-05-2012, 05:31 PM
Re: Inlet stud help - by Ricky - 08-05-2012, 05:36 PM
Re: Inlet stud help - by Ben - 08-05-2012, 05:57 PM
Re: Inlet stud help - by Ricky - 08-05-2012, 06:01 PM
Re: Inlet stud help - by Ruan - 08-05-2012, 07:53 PM
Re: Inlet stud help - by Ricky - 08-05-2012, 08:30 PM
Re: Inlet stud help - by mark_airey - 21-05-2012, 07:11 AM
Re: Inlet stud help - by Ricky - 21-05-2012, 04:07 PM
Re: Inlet stud help - by Dave - 22-05-2012, 10:22 AM
|
| Possibly Related Threads… | |||||
| Thread | Author | Replies | Views | Last Post | |
| ARP head stud xud9ate | niciou | 9 | 3,955 |
14-04-2016, 03:09 PM Last Post: Gitshdtub |
|
| Head bolt/ stud - thread pitch & width | anto | 2 | 1,844 |
29-07-2014, 10:09 AM Last Post: anto |
|
| Cylinder head mani stud hole thread spacing | 306Puggy | 7 | 2,711 |
06-04-2014, 01:40 PM Last Post: 306Puggy |
|
