20-01-2017, 04:22 PM
(This post was last modified: 20-01-2017, 04:24 PM by JTaylor2005.)
If you want to keep flow good I'd say stick with a straight through style silencer just with perforated walls and fibers packed round the tube. Any kinks twists and splits will just disrupt flow tbh
And if it enters the pipe on an angle or leaves on an angle try and get the pipe bent rather than just cut across and welded on at an angle
And if it enters the pipe on an angle or leaves on an angle try and get the pipe bent rather than just cut across and welded on at an angle
