Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Diff bearings
#14
ok, so its not the right way.

but if you get some stud bar, use that to replace the stripped bolt. I know the thread in the housing has gone, but it only looks like the first few. The stud bar will go all the way in, and be a much better anchor.

just make sure you cut it long enough Smile plenty of sealant, leave it to set, then put some box oil in there. it is 100% a bodge, but if it works, and gets the car back on the road, well it will be 1 less problem to sort out. Just let the new owner know Smile
Not always Grumpy!!
306 Cabby SE, 2.0l 16v 
To the optimist, the glass is half full. To the pessimist, the glass is half empty. To the engineer, the glass is twice as big as it needs to be!

Reply
Thanks given by:


Messages In This Thread
Diff bearings - by Toms306 - 13-05-2016, 07:04 PM
RE: Diff bearings - by insomaniac45 - 13-05-2016, 07:27 PM
RE: Diff bearings - by Paul_13 - 13-05-2016, 07:27 PM
RE: Diff bearings - by Toms306 - 13-05-2016, 07:42 PM
RE: Diff bearings - by insomaniac45 - 13-05-2016, 07:46 PM
RE: Diff bearings - by Toms306 - 13-05-2016, 07:47 PM
RE: Diff bearings - by Paul_13 - 13-05-2016, 07:48 PM
RE: Diff bearings - by insomaniac45 - 13-05-2016, 07:54 PM
RE: Diff bearings - by Paul_13 - 13-05-2016, 07:56 PM
RE: Diff bearings - by Toms306 - 13-05-2016, 08:48 PM
RE: Diff bearings - by Paul_13 - 13-05-2016, 08:57 PM
RE: Diff bearings - by bashbarnard - 13-05-2016, 09:10 PM
RE: Diff bearings - by Toms306 - 13-05-2016, 09:14 PM
RE: Diff bearings - by insomaniac45 - 13-05-2016, 09:37 PM
RE: Diff bearings - by welshpug - 13-05-2016, 10:36 PM
RE: Diff bearings - by Toms306 - 13-05-2016, 10:51 PM
RE: Diff bearings - by Toms306 - 14-05-2016, 09:41 AM
RE: Diff bearings - by 1616six - 14-05-2016, 09:45 AM
RE: Diff bearings - by Toms306 - 14-05-2016, 09:50 AM

Forum Jump:


Users browsing this thread: 1 Guest(s)