02-02-2016, 05:38 PM
If I remember right the end of the cable is moulded into the handle. I think if you pop the wiper motor off you get access to the ball grommet under there.
Like you say best way to fit the new one would be to tie a string to the bonnet end and pull the old one through. When I did it the end did get caught in a couple of places but if you push then pull again it will unhook its self.
Like you say best way to fit the new one would be to tie a string to the bonnet end and pull the old one through. When I did it the end did get caught in a couple of places but if you push then pull again it will unhook its self.