flywheel sensor

[pugtk]

which flywheel are you using?

should be a 1mm gap IIRC, new sensors come with tabs on the end which are 1mm tall so you just bung it in the hole till it touches and they wear off if there's any discrepancy in the flywheel.

Using the xud7 (d turbo flywheel) which was used before,

Is there a different mounting point on the xud7 for the flywheel sensor?

Something tells me that the flywheel sensor clamp was different, I used the xud9 flywheel sensor clamp

I pushed the sensor right into the flywheel where it stopped on the tabs (this also didn't work)