Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
205 speedlines
#3
will be fine as long as your beam isn't cambered, could do with 5mm spacers on the back but i never ran them . . .whhel weights sometimes catch for about 5mins then they don't after being worn down . .Big Grin
Phase 1 D-Turdo, K14@24 psi, De-cat, meaty backbox, Bosch pump, grinded LDA pin, duel air fed K&N =133.7bhp & 188ft/lbs
Reply
Thanks given by:


Messages In This Thread
205 speedlines - by willJspears - 29-09-2014, 09:53 PM
RE: 205 speedlines - by Daniel306 - 29-09-2014, 09:56 PM
RE: 205 speedlines - by Mattcheese31 - 30-09-2014, 07:51 PM
RE: 205 speedlines - by bashbarnard - 30-09-2014, 08:00 PM
RE: 205 speedlines - by willJspears - 30-09-2014, 09:44 PM
RE: 205 speedlines - by Mattcheese31 - 30-09-2014, 10:57 PM
RE: 205 speedlines - by willJspears - 01-10-2014, 07:29 AM

Forum Jump:


Users browsing this thread: 1 Guest(s)