29-04-2014, 03:01 PM
bearings tend not to have any grease at all from the factory, you grease them up when fitting...
you wont get grease in there by sticking it on the shaft as the seal on the bearing will wipe it off.
WD40 is shite for jobs like these, you need to use a penetrating oil/fluid, WD40 is not one of those.
you wont get grease in there by sticking it on the shaft as the seal on the bearing will wipe it off.
WD40 is shite for jobs like these, you need to use a penetrating oil/fluid, WD40 is not one of those.