04-04-2014, 03:25 PM
Swapped this no bother today. 
I was counter holding a droplink bolt with a spanner undoing the nut, wasn't any real force on it at all tbh.

(03-04-2014, 10:51 PM)Ruan Wrote: The torx bits go real easy if you put any side loading on them... Once you make sure you apply force directly, rather than yanking at a funny angle... I've snapped a few and it's always from not having it in right or using it at a funny angle...
I was counter holding a droplink bolt with a spanner undoing the nut, wasn't any real force on it at all tbh.
