Jons Wagon Thread. Questions will be asked (a lot)

[Dum-Dum]

Blatantly stole this link. Pretty much a blow by blow fitting guide for HDI Fmic.
http://www.club-306.com/topic/12625-hdi-...r-fitting/

Theres a few bits I dont like in that guide but Its not bad.
Dont cut down a bottom pipe as itll split.
Dont bother with gasket paper as the proper gasket is pennies
And try and use as few joiners as possible as theres one bit where hes got about half a dozen clamps within a foot of pipe run. If you want to join metal to metal get them welded.

Finally sorted out my hockey stick.
My pug finaly doesn't look like it's had a stroke.
LMFAO.
Still missing the cap for my roof bar... doh!

So, a question....

I've got half leather seats that are well past their prime.
Can I swap them out for another set of 5 door seats?
Also I have grey cloth door cards, can they be swapped out so they match the seats?
Do they need to be phase specific and are they straight swap from a 5 door?

Depending on how bad your 5dr seats are I'd do a straight swap for my BMW ones and their mounts

Oh and any 5dr seats will fit out of any phase but early ones wont have the airbags.