07-08-2013, 10:32 PM
Time for a update, will update again in the morning with some over all pictures of the car as it stands!!
First up,
Sprayed my tail gate finally
Took a while to wire in the ph3 loom but about a hour or so later and a role of electrical tape it was finaly finished.
Next up my leather stitched steering wheel.
Very nice!!!
The same day I through I would have a good at changing the beams over, took a while to get the break pipes off, had to use mole grips in the end. =\
Old beam off and stripped and put on the new beam.
All on and looking smart, also put new copper break lines on!!! the break fluid was discoloured and mancky, so new stuff go put in
The new ride height at least 30mm drop,
It has since settled after taking the picture so I will upload the finishing picture after I take them tomo,
First up,
Sprayed my tail gate finally
Took a while to wire in the ph3 loom but about a hour or so later and a role of electrical tape it was finaly finished.
Next up my leather stitched steering wheel.
Very nice!!!
The same day I through I would have a good at changing the beams over, took a while to get the break pipes off, had to use mole grips in the end. =\
Old beam off and stripped and put on the new beam.
All on and looking smart, also put new copper break lines on!!! the break fluid was discoloured and mancky, so new stuff go put in
The new ride height at least 30mm drop,
It has since settled after taking the picture so I will upload the finishing picture after I take them tomo,