18-07-2013, 09:16 PM
(17-07-2013, 11:28 PM)Welshy_Pete Wrote: I got the central locking working in the end. I put anther door piller loom in. So that sorted out afew things. The central locking still wouldn't work. So I got anther motor connected it to the loom connector and it worked fine.
You could lock the doors on the driver side only manual with the key due to that motor not working. But could open and close the others once the driver door was locked using the remote. But the driver side wouldn't with the remote due to the motor.
So now I've fitted a new motor on the car its working great now.
My rear back wiper motor would work sometimes like the front one as well. Then they both packed in after so changed the motor on the front fixed that. I left the back one blank but the motor had gone also as well.
The way I removed the door motor was to disconnect the wiring connector off. Then unscrew the 3 torx on the outside of the door near the door catch. There maybe a plastic black cover to take of as well before you can get to the motor. Take of the door pin lock latch which you unlock the door and lock with by hand.
This is were is gets hard there not much room inside. I had to twist the motor side ways to get it out and of the key lock latch holding it on place. Once the motor loose you need to disconnect the rest of the metal latches off.
I managed to do it all but getting it back on the top metal latch was the hardest to get back in place to clip in properly.
