01-07-2013, 10:16 AM
have been out and fitted new exhust rubbers as the old ones were shot,
have stopped the rattle from the rear heat sheild, snapped bolts! so ground the studs off and drilled and fitted a threaded insert to the underfloor so now i have a firm screw point and no rattle once bolted up
and ive had another look at what i thought was a bent stub axel
well i dont think it is now as the Camber on the printout is correct
its only the Toe thats out
when i look at the readings on the printout i realised the N/s is toe in and the O/s is toe out
so out with the tape measure and the beam is not square!
probably after ive done the beam mounts D O H!!!!!!
O/S is about 5mm further back than the N/s
so tomorrow mornings job is to square up the beam
have stopped the rattle from the rear heat sheild, snapped bolts! so ground the studs off and drilled and fitted a threaded insert to the underfloor so now i have a firm screw point and no rattle once bolted up
and ive had another look at what i thought was a bent stub axel
well i dont think it is now as the Camber on the printout is correct
its only the Toe thats out
when i look at the readings on the printout i realised the N/s is toe in and the O/s is toe out
so out with the tape measure and the beam is not square!
probably after ive done the beam mounts D O H!!!!!!
O/S is about 5mm further back than the N/s
so tomorrow mornings job is to square up the beam