306oc - Peugeot 306 Owners Club & Forum › Engines › XUD Section v
Cutting boost holes!!

Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Cutting boost holes!!
silverzx Offline
Always leaves skidz

Registered users - Donated
Posts: 4,926
Threads: 266
Joined: Dec 2011
Reputation: 18
Location: Somerset
Car Model/Spec: 205 DTurbo
Thanks: 73
Given 7 thank(s) in 7 post(s)
#6
10-05-2013, 11:17 PM
(10-05-2013, 09:29 AM)darrenjlobb Wrote: plasma cutter / hole saw / jigsaw if your feeling rash....
note, on mine i slid a silicon up over the hose where it went through to stop any knocking / protect it a bit.

Ordered a set of cheapy hole saws with sizes from quater inch up to 2 and a half inches I think.

I'll give them a go before anything! Smile
Supercharged GTi6 Build
S14 Zenki Build
[Image: signature.png]
Find
Reply
Thanks given by:


Messages In This Thread
Cutting boost holes!! - by silverzx - 07-05-2013, 11:20 PM
RE: Cutting boost holes!! - by samass - 07-05-2013, 11:37 PM
RE: Cutting boost holes!! - by silverzx - 07-05-2013, 11:45 PM
RE: Cutting boost holes!! - by samass - 07-05-2013, 11:58 PM
RE: Cutting boost holes!! - by darrenjlobb - 10-05-2013, 09:29 AM
RE: Cutting boost holes!! - by silverzx - 10-05-2013, 11:17 PM
RE: Cutting boost holes!! - by ozonehostile - 10-05-2013, 11:32 PM

Possibly Related Threads…
Thread Author Replies Views Last Post
  Flywheel has two timing holes? Fozzy 14 7,840 28-08-2012, 10:09 PM
Last Post: CJ_Derv

Forum Jump:


Users browsing this thread: 1 Guest(s)