+- 306oc - Peugeot 306 Owners Club & Forum (https://www.306oc.co.uk/forum)
+-- Forum: Engines (https://www.306oc.co.uk/forum/forumdisplay.php?fid=16)
+--- Forum: XUD Section (https://www.306oc.co.uk/forum/forumdisplay.php?fid=11)
+--- Thread: Cutting boost holes!! (/showthread.php?tid=13631)
Cutting boost holes!! - silverzx - 07-05-2013
Anyone able to recommend a drill bit / piece / thing for cutting 3" holes in my chassis nice and easily for boost pipes to run through? Don't really fancy cutting squares and covering with spare rubber window/door seals!
RE: Cutting boost holes!! - samass - 07-05-2013
Holes saw.
RE: Cutting boost holes!! - silverzx - 07-05-2013
(07-05-2013, 11:37 PM)samass Wrote: Holes saw.
Thats the name then! I can look myself now I know what there called.
RE: Cutting boost holes!! - samass - 07-05-2013
But without the extra s
RE: Cutting boost holes!! - darrenjlobb - 10-05-2013
plasma cutter / hole saw / jigsaw if your feeling rash....
note, on mine i slid a silicon up over the hose where it went through to stop any knocking / protect it a bit.
RE: Cutting boost holes!! - silverzx - 10-05-2013
(10-05-2013, 09:29 AM)darrenjlobb Wrote: plasma cutter / hole saw / jigsaw if your feeling rash....
note, on mine i slid a silicon up over the hose where it went through to stop any knocking / protect it a bit.
Ordered a set of cheapy hole saws with sizes from quater inch up to 2 and a half inches I think.
I'll give them a go before anything!
RE: Cutting boost holes!! - ozonehostile - 10-05-2013
hole saw then jig saw to make the hole bigger. file off the edges then as darren says, piece of hose in the hole to stop rattles/damage to pipe