|
Cutting boost holes!!
|
Posts: 4,604
Threads: 90 Joined: Dec 2011 Reputation: 54 Location: Cornwall Car Model/Spec: 1996 306 DT M-TDI/16 
Thanks: 0
Given 20 thank(s) in 18 post(s)
10-05-2013, 09:29 AM
(This post was last modified: 10-05-2013, 09:30 AM by darrenjlobb.)
plasma cutter / hole saw / jigsaw if your feeling rash....
note, on mine i slid a silicon up over the hose where it went through to stop any knocking / protect it a bit. | Dyno Power Runs & Steady State Facilities Available, Just Ask Anytime |
| #DervMafia | ![[Image: sigi-2.png]](http://i281.photobucket.com/albums/kk226/darrenjlobb/sigi-2.png) |
|
« Next Oldest | Next Newest »
|
| Messages In This Thread |
|
Cutting boost holes!! - by silverzx - 07-05-2013, 11:20 PM
RE: Cutting boost holes!! - by samass - 07-05-2013, 11:37 PM
RE: Cutting boost holes!! - by silverzx - 07-05-2013, 11:45 PM
RE: Cutting boost holes!! - by samass - 07-05-2013, 11:58 PM
RE: Cutting boost holes!! - by darrenjlobb - 10-05-2013, 09:29 AM
RE: Cutting boost holes!! - by silverzx - 10-05-2013, 11:17 PM
RE: Cutting boost holes!! - by ozonehostile - 10-05-2013, 11:32 PM
|
| Possibly Related Threads… | |||||
| Thread | Author | Replies | Views | Last Post | |
| Flywheel has two timing holes? | Fozzy | 14 | 7,146 |
28-08-2012, 10:09 PM Last Post: CJ_Derv |
|
