Project smokey

[Parksy87]

Yesterday i plasti dipped my interior light surround and was happy with the outcome:

To:


Bit of work done today ash306 came down to give me a hand (do most of) the bodywork, got it jacked up so we could reach the inside of the arch to start knocking it out got it looking pretty straight with the exception of 2 area's which couldnt be reached so it then got a sanding:

Then it was time for filler so ash mixed some p38 slapped it on once cure we started giving it another sand to smooth it out also started attacking the door
As it stands the drivers side needs a bit more filler in 2 areas 1 on the rear arch and 1 on the door pillar but apart from that its looking pretty damn straight needed to sealthe filler untill a bit more can be done weather was a bit pants for spraying primer on so i got my brush out and slapped some red oxide on:

I know it doesnt look brilliant but its doing the job and very happy with how ash managed to keep/make the bodyline
No going back now the sigma will be going but change is good right?

Ash and jack the pooch had to get back so i thought id have a mess on the inside and put something a little different on/in it, out with the grey grab handles and in with some 106 quicksilver ones


Then i went into the garage and made a start on removing the bushes off the spare arms ready to put the powerflex bushes on, grinder, fire, chizel and lump hammer and the P bushes were off

Need to get my punches from my moms so i can remove the front bushes but quite happy with whats been done today.

Comments and criticism welcome as always
Lots of love Wendy x