oil-burner's bitchin HDi project - soon to be stage 2!

[Oil-burner]

You'll need a few reducers 2.5 > 2.25 reducers, I'm sure the elbow is 2.25 but i can't remember the c5 pipe.

Are you going for OEM piping? You might need to grind the slam panel a little bit too. All good fun

Hmmm im tempted just to reduce both pipes at the cooler and work with 2.25 but it depends what I can get on the cheap!

Yeah mate im hoping to as much as possible, wanting it full on stealth, painting cooler black at the weekend. But as I say just depends what I can get on the cheap, want to get the whole lot done for under a ton.

I thought the elbow was 2.5 but I might b wrong! I'll let you no 2moro. You will need to cut the slam panel, makes its bit easier if anything!!

The c5 pipe goes from 38mm to 54mm so you need a 38-38 90° for turbo to c5. I used a 41mm bend cos the turbo was slightly bigger being a ko4.

Doesnt matter about the elbow cos im gonna use the c5/406 top pipe too.
If we could confirm measurements on the c5 pipe tho it would be epic!

Yeah kinda knew id end up cutting it tbh no biggie
Has anyone tried using the slimline fan from the c5?

Really? The bit of pipe that usually comes on the elbow, im running some 2.25 piping into that.

Also I used a 41mm to 45mm 90 degree legged bend off the Turbo onto c5.

So do we have any idea on the c5 to turbo reducer I need?