Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Turbo oil feed thread size
#3
Piggy has just measured one for me and its M16x1.5 on the 2.1TD

Hes got a pic of it next to a pug wheel bolt (M12x1.25) and the thread pitch is definitely coarser but not by alot so im gonna suggest that its right.



piggy Wrote:the thread gap appears to be 1mm by the gauge...
[Image: 20130113_132645.jpg]
[Image: 20130113_132706.jpg]
certainly not a 306 bolt thread
[Image: 20130113_132901.jpg]
and not tapered

and it aint same pitch as a M6 or any bolts I could find in me bolt drawer!

hope this helps too
[Image: 20130113_132509.jpg]

The low pressure side...
[Image: 20130113_132552.jpg]
hope that helps?! That piece pushes into the block...can be seen in photo.
Reply
Thanks given by:


Messages In This Thread
Turbo oil feed thread size - by Dum-Dum - 12-01-2013, 03:28 PM
RE: Turbo oil feed thread size - by Ricky - 12-01-2013, 04:27 PM
RE: Turbo oil feed thread size - by Dum-Dum - 13-01-2013, 04:54 PM
RE: Turbo oil feed thread size - by strictly_perv - 13-01-2013, 06:09 PM
RE: Turbo oil feed thread size - by darrenjlobb - 13-01-2013, 06:13 PM
RE: Turbo oil feed thread size - by Dum-Dum - 13-01-2013, 06:45 PM

Possibly Related Threads…
Thread Author Replies Views Last Post
  turbo relocation pipe size Chris_90 10 4,893 08-08-2015, 12:32 AM
Last Post: Paul Baldwin
  Twin turbo high pressure oil feed setup. 205dtub 17 5,421 23-02-2015, 07:47 PM
Last Post: 205dtub
  What thread is fuel feed for a bosch? silverzx 8 3,382 04-02-2015, 03:51 PM
Last Post: silverzx

Forum Jump:


Users browsing this thread: 1 Guest(s)