Turbo oil feed thread size - Printable Version

Turbo oil feed thread size - Printable Version

+- 306oc - Peugeot 306 Owners Club & Forum (https://www.306oc.co.uk/forum)
+-- Forum: Engines (https://www.306oc.co.uk/forum/forumdisplay.php?fid=16)
+--- Forum: XUD Section (https://www.306oc.co.uk/forum/forumdisplay.php?fid=11)
+--- Thread: Turbo oil feed thread size (/showthread.php?tid=9731)

Turbo oil feed thread size - Dum-Dum - 12-01-2013

Anyone know the thread size of the block for having an oil feed made Think its M14 or M16 but i have no idea of the pitch.

Just gonna get an AN4 or AN6 line and adapters.

RE: Turbo oil feed thread size - Ricky - 12-01-2013

M16 x 1.5 iirc

RE: Turbo oil feed thread size - Dum-Dum - 13-01-2013

Piggy has just measured one for me and its M16x1.5 on the 2.1TD

Hes got a pic of it next to a pug wheel bolt (M12x1.25) and the thread pitch is definitely coarser but not by alot so im gonna suggest that its right.

piggy Wrote:the thread gap appears to be 1mm by the gauge...

certainly not a 306 bolt thread

and not tapered

and it aint same pitch as a M6 or any bolts I could find in me bolt drawer!

hope this helps too

The low pressure side...

hope that helps?! That piece pushes into the block...can be seen in photo.

RE: Turbo oil feed thread size - strictly_perv - 13-01-2013

Don't know if this is any help to you at all but if you have any power steering pipes lying about, the bolt is the exact size for the block. Well 205 one's are anyways.

RE: Turbo oil feed thread size - darrenjlobb - 13-01-2013

(13-01-2013, 06:09 PM)strictly_derv Wrote: Don't know if this is any help to you at all but if you have any power steering pipes lying about, the bolt is the exact size for the block. Well 205 one's are anyways.

Same on 306 also Smile

RE: Turbo oil feed thread size - Dum-Dum - 13-01-2013

Erm, I dont think so, I do have an electric PAS pump though