HP Fuel Pump FPR Bolts

[BiG K]

Does anyone have a broken HP fuel pump and willing to send out the bolts from the FPR? or if not, the size of the bolts so I can grab some replacements? (Both of mine have corroded and the head's are FXXXED!) Ta in advance!

[tigerstyle]

Same request on bolt size please

Think it's M6 currently?

[BiG K]

I ended up buying a whole fuel pump for the two bolts haha. I'll get it measure up tomorrow for you!

[tigerstyle]

M6*15mm

[BiG K]

M6 * 15mm is correct. Has a T30 Torx head.

[pug306driver]

whats the pitch please??

[BiG K]

No idea how to measure pitch, I think it's standard? I've included a photo if that helps.

[welshpug]

Probably 1.0mm pitch, use the links below to find them

[tigerstyle]

Probably 1.0mm pitch, use the links below to find them

And yeah it's 1mm

AFAIK not listed, servicebox is not all that. 
I looked yesterday, does have the o-ring specs though.

[BiG K]

The O-rings are cheap enough to buy....if your dealer will get them in. Some O rings are supplied in packs of 5, some in 4 and some in 3... they were being a bit arsey with me when I went to go buy the O rings.

[pug306driver]

cool, thanks, fore armed etc., looks as if a 10mm hex head will fit??

[Poodle]

You might find you have clearance issues getting a socket over it, being so close to the solenoid body as they are.

[tigerstyle]

Yeah, hex head is a no go. Bolt won't even fit let alone the socket.
In a pinch you could use a 30mm long bolt and a 15mm spacer, but not recommended.

[pug306driver]

thanks, will go down the allan bolt route