Posts: 235
Threads: 50
Joined: May 2013
Reputation:
0
Location: Herts
Car Model/Spec: 306 HDI Dturbo
Hi all
Bought an egr blank from eBay (made out of stainless steel and rumbled for smoothness.) Fitted it yesterday but realised after I hasn't put any gaskets on it. I just slid it in (wasn't much room to separate the flexi pipe from the inlet) and tightened it up. I don't think it is leaking, any way to tell?
Thanks
Posts: 13,881
Threads: 476
Joined: Dec 2011
Reputation:
81
Location: Ipswich
Car Model/Spec: 306 Rallye
I bought the same one but never fitted. Should be able to use some gasket sealant on it if youre worried.
Posts: 198
Threads: 30
Joined: Dec 2012
Reputation:
1
Location: Wirral
Car Model/Spec: 01 HDI Estate
I got that one off eBay too, slotted in, no gasket either. Tbh I can't see any big problems with it, even if it is letting by it'll only be into engine bay as it's serving its purpose it's a big ass flat faced blockage in the middle of the pipe stopping the gasses travelling through. Have you also removed and blocked the vac line too?
Posts: 235
Threads: 50
Joined: May 2013
Reputation:
0
Location: Herts
Car Model/Spec: 306 HDI Dturbo
I had already blocked the vac line. It all seems ok so I think I'll leave it for now. The inlet elbow gasket is leaking oil a bit (common problem) so I think I'll just wait until I do the gasket on that and maybe put some instant gasket on the blanking plate.
Thanks guys
