Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Danny's 7th D turbo, *BEEN BROKEN*
Yea be ideal if you could mate cheers Smile
[Image: image_zps45f2003b.jpg]

Team Doesn't own a 306
Losing the love with this ATM

Bought these today

[Image: image_zpsf9e9ff1b.jpg]

Because they was due it was undriveable

[Image: image_zpsee344c12.jpg]

[Image: image_zps12ac17f1.jpg]

Oh and got this in the boot

[Image: image_zps04eca69f.jpg]

70hp shot straight into engine

Cheers
[Image: image_zps45f2003b.jpg]

Team Doesn't own a 306
Anyway you can make NOS shoot out the front wings like in the movies? Tongue
Supercharged GTi6 Build
S14 Zenki Build
[Image: signature.png]
You can buy kits for that cheaper than the kit I have buy why waste it when you can make moar power :p
[Image: image_zps45f2003b.jpg]

Team Doesn't own a 306
Haha, would be pretty bad ass yo! Tongue

Will be funny to have NOS though! Dragracecarftw.
Supercharged GTi6 Build
S14 Zenki Build
[Image: signature.png]
Shame on you Danny...no neons !!!



lmao
[Image: siggy1.jpg]

the smokey old bus that sounds like a tractor...
Think I've plumbed it in wrong the dials aren't going blurry
[Image: image_zps45f2003b.jpg]

Team Doesn't own a 306
(16-10-2013, 09:45 PM)Danny2009 Wrote: Think I've plumbed it in wrong the dials aren't going blurry

lmao



Does the nitrous actually make much difference?

How are you using it, just flat out or are you spooling the turbo with it?
Definitely makes a lot of difference and spools the turbo up like its a t2 if you use it right it burns off the unused fuel (coal) so it's clean when using it

Few people have said no don't do it it's shite it won't work go water meth bla bla

Well it works well
[Image: image_zps45f2003b.jpg]

Team Doesn't own a 306
On the rr day one car made 30/40bhp more but I'd be more concerned with it burning to lean as there's no smoke. It's ok for quick blasts
Perv 106 1.4 xs First Pug Love - Scrapped
Perv 306 1.6 5 Door Hore - Sold
110bhp 207 Hdi Sport - Used as a Brake
173bhp T25 Ph1 Diablo Dturbo - Scrapped
Thirsty Bitch Volvo 850 Estate - Sold
51bhp Berlingo Nad DT Van - Sold
Slow as f*ck Dispatch Work Horse

www.prestige-auto-care.co.uk
[Image: image_zps47e5d80b.jpg]

Quite amusing looking into the rear view mirror to see bits of engine flying down the motor way
[Image: image_zps45f2003b.jpg]

Team Doesn't own a 306
Oh dear! Sad
So the nitros worked a bit too well?
[Image: car-1.jpg]

Member of the 99% warning or you're nothing club


2000 Moonstone 1.8 Meridian - Sold
2000 China 3dr XS - Dead
1998 Diablo 3dr XSI
Haven't used the nitrous for around 2 weeks not sure what happened
[Image: image_zps45f2003b.jpg]

Team Doesn't own a 306
At a guess, it went boom!
[Image: 20A1806D-891D-40FB-BD52-AD519177A607-734...391753.jpg]
TEAM CONROD SHITTING RALLYE!
Safe to say it went boom just insure of the cause
[Image: image_zps45f2003b.jpg]

Team Doesn't own a 306
Probably part of the inside of the engine, exiting the engine, and therefore becoming part of the outside of the engine?
[Image: car-1.jpg]

Member of the 99% warning or you're nothing club


2000 Moonstone 1.8 Meridian - Sold
2000 China 3dr XS - Dead
1998 Diablo 3dr XSI
(28-10-2013, 01:43 PM)Grant Wrote: Probably part of the inside of the engine, exiting the engine, and therefore becoming part of the outside of the engine?

lmao

Oh dear on wards and upwards? Or strip it?



Uh oh. New engine time?
Current stable
'09 Mercedes E320cdi wagon 
'99 306 gti6
time for a rebuild with more uprated parts.
Not sure where to go from here. Was going to strip it 2 weeks ago so not sure on its fate yet
[Image: image_zps45f2003b.jpg]

Team Doesn't own a 306
(28-10-2013, 02:25 PM)procta Wrote: time for a rebuild with more uprated parts.

this ^^^^ you went too big with too little to back it up imo . .Smile x
Phase 1 D-Turdo, K14@24 psi, De-cat, meaty backbox, Bosch pump, grinded LDA pin, duel air fed K&N =133.7bhp & 188ft/lbs
Go big or go home IMO could do with forged rods but haven't decide what to do yet
[Image: image_zps45f2003b.jpg]

Team Doesn't own a 306
Sorry about the news Danny, at least the engine breaths better now Big Grin
[Image: siggy1.jpg]

the smokey old bus that sounds like a tractor...
(28-10-2013, 03:31 PM)Danny2009 Wrote: Go big or go home IMO could do with forged rods but haven't decide what to do yet

yeah go big mate but you need those forged rods or similar or you'll never have a car to get you home . . . . . Blush
Phase 1 D-Turdo, K14@24 psi, De-cat, meaty backbox, Bosch pump, grinded LDA pin, duel air fed K&N =133.7bhp & 188ft/lbs
ahhh fiddle sticks

were you running standard internals?
Yea completely standard d8a tom thinking of getting a winter run about as it was coming off the road soon as the gritters came out just a little earlier than I thought :/ just don't think I've got it in me to break it up for parts but see what happens
[Image: image_zps45f2003b.jpg]

Team Doesn't own a 306
dont break it!

fresh block, few modifications and you'll be back to the coaling ways....
I've got a spare engine so wouldn't mind building one proper
[Image: image_zps45f2003b.jpg]

Team Doesn't own a 306


Possibly Related Threads…
Thread Author Replies Views Last Post
  Danny's TD04 Blaze D Turbo. Danny Wideboy 66 32,150 10-06-2014, 10:34 AM
Last Post: RetroPug
  Ph1 Diablo D-turbo - Being Broken Up! Jenkosowls 305 208,281 26-05-2013, 12:44 AM
Last Post: ozonehostile
  Danny's D-Turbo estate Danny2009 17 8,627 14-12-2012, 08:46 AM
Last Post: Danny2009

Forum Jump:


Users browsing this thread: 1 Guest(s)