Posts: 172
Threads: 20
Joined: Nov 2015
Reputation:
0
Location: Dublin, Ireland
Car Model/Spec: Phase 1 Genoa
My power steering is making a horrible grinding noise so I've decided that I'm going to remove it.
I've got a pretty good idea on what to do but I'm just wondering are there any do's or dont's ?
Also while I'm bothered, is there anything else I can do to improve the steering ?
Posts: 730
Threads: 26
Joined: Feb 2013
Reputation:
4
Location: Monaghan/fermanagh.
Are you removing it completely? With it making a noise its probably only the pump that's done if its been run low on fluid, handy fix if so.
Or maybe your just replacing the pump if so its only a matter of taking of the fan belt of the p/s pulley, removing the high pressure pipe and feed pipe and taking out the bolts that hold it on.
Posts: 20,092
Threads: 591
Joined: Nov 2012
Reputation:
54
Location: Cotswolds
Car Model/Spec: Stage 13 16v HDi
Replacing pump is a 30min job...and maybe just a fiver for a pump!
Posts: 18,242
Threads: 386
Joined: Dec 2011
Reputation:
87
Location: Suffolk
Car Model/Spec: Focus Titanium
Don't remove it...
Have you tried parallel parking or navigating tight streets without PAS lol?
Posts: 172
Threads: 20
Joined: Nov 2015
Reputation:
0
Location: Dublin, Ireland
Car Model/Spec: Phase 1 Genoa
I'm thinking of removing it completely as its not a very heavy car. Tom what are they like ? Cause I've driven older cars with very heavy steering and I didn't find them too bad. It's just making a horrible grinding noise I haven't done a anything at all with the system and I was just thinking it might be better to remove it
Posts: 18,242
Threads: 386
Joined: Dec 2011
Reputation:
87
Location: Suffolk
Car Model/Spec: Focus Titanium
It'll be fine on the road, but slow speed town or parking will be a pain.
It'll be better to chuck another pump on, its like 3 bolts and a couple of pipes...
Posts: 1,950
Threads: 55
Joined: Dec 2011
Reputation:
17
Location: Rotherham
Car Model/Spec: 406 V6
It's fine, but to do it properly you want to weld up the shuttle valve.
Custom roll cages/shiny suspension bits/general fabrication work undertaken, PM me.
Top engine mount repair/reinforcement/chocking for cracked chassis and high powered cars, drive in, drive out, 2 hour turnaround.
Posts: 172
Threads: 20
Joined: Nov 2015
Reputation:
0
Location: Dublin, Ireland
Car Model/Spec: Phase 1 Genoa
Yeah replacing it looks easier then welding lol. I can get a new pump when I'm down in the scrappy next week or the week after. Gonna be on the hunt for something with an xud aswel so things are gonna get interesting soon
