tilting engine forward

[therefused]

when tilting the engine forward i am aware i need to put a jack under the engine and undo the top mount.

is there anything else i need to be aware of? i.e removing certain pipes ect i dont want to crush something.

thanks

[strictly_perv]

Jack engine to remove pressure, remove top mount bracket. Done.
Some say its good to put some padding on the jack face to protect the sump but I've never bothered

[kentiiboii]

Just small bit of wood will do.

[Just Sean]

That's what I used on the hdi.

[karl1989]

I use rubber piping like a boost hose

[HDIkyle]

Steel sump I never bother. Might need to undo exhaust depending how far forward your going

[4WayDiablo]

Watch out for the coolanthose off the front of the block. I rocked it too far and it split the hose on the rad

[306Puggy]

Yeah mate just use a block of wood wedged between the head and the bulkhead to hold it in place. There is a cut out in the chassis which is where I usually wedge it. As for the sump just jack it right on the corner if you don't have a block of wood as that is it's strongest point.