masks information please

[dr_jekyll]

Looking at putting crystal lenses onto a ph2 boddy for a different look.
Problem is my ovens too small and dont own a heat gun, is there any other way to seperate the lenses?

[Toms306]

It won't work anyway, the ph2 lights need the frosty bit for the beam pattern.

[dr_jekyll]

Seen it done before and will be ran with hid's

[Connor]

People also jump off of bridges and cliffs, doesnt mean you should do it much easier to just fit some ph3 crystals whole

[Toms306]

Get some projectors if you want to run HIDs tbh.

But to answer the original question, you do need heat to separate the glue. Heat gun probably doesn't cost much though?

[dr_jekyll]

Im already running crystals, looking for some thing abit different though rather than moretts and angels.
Sounds stupid but would a hairdryer work pmsl. GoNana aplly yellow tint film after

[Jimbo]

This makes no sense IMO, PH2 lights with a crystal lense and there not twin optic??

Massive downgrade from ph3s

[Niall]

This makes no sense IMO, PH2 lights with a crystal lense and there not twin optic??

Massive downgrade from ph3s

This. Being different isn't always better!

[Slam Wagon]

Just wrap your crystals. Will look the same and work better.