16-05-2016, 05:26 PM
Did a bit more towards fcs and general jobs that wanted doing.
Replaced o/s/r caliper as it was not really doing anything other than dragging the right rear wheel. So thats guna help things now its not seized.
Then started on "cooling". Basically wanted to move the fmic/rad closer to avoid air stall, add some cowling to improve air flow and reduce losses, add an oil cooler and make a sort of air box for the big air filter.
So front end off and assess and access things...
Some cutting, hammer and general magic later...
Not a bad result, pretty happy, they are as close as is possible now.
Need some shrowding around each side and maybe bottom and then an oil cooler I hope to fit to the side in front of washer bottle
Replaced o/s/r caliper as it was not really doing anything other than dragging the right rear wheel. So thats guna help things now its not seized.
Then started on "cooling". Basically wanted to move the fmic/rad closer to avoid air stall, add some cowling to improve air flow and reduce losses, add an oil cooler and make a sort of air box for the big air filter.
So front end off and assess and access things...
Some cutting, hammer and general magic later...
Not a bad result, pretty happy, they are as close as is possible now.
Need some shrowding around each side and maybe bottom and then an oil cooler I hope to fit to the side in front of washer bottle
Wishes for more power...