15-08-2016, 09:37 PM
The head is on the car!! was a bit tricky at 1st lining up the head with the dowels, but it went on. The me and my dad went through the full blown sequence. Our Degree gauge dropped to bits, by sending a square nut into the head, which we thought ffs!! We were so close! We managed to get that fucker out with magnetic screw driver.
I started to feed the wiring back on to the car, but one of the connector ends has been took off, no doubt my dad again. So more fuckin wiring to do!
Tomorrow if the weather is spot on, I hope to get the sump back on and exhaust manifold on. and maybe get the timing belt on! Still a long away off though from the big one.
I started to feed the wiring back on to the car, but one of the connector ends has been took off, no doubt my dad again. So more fuckin wiring to do!
Tomorrow if the weather is spot on, I hope to get the sump back on and exhaust manifold on. and maybe get the timing belt on! Still a long away off though from the big one.