Spraying interior trim

[Bananalad]

Spraying my 'a' and 'b' pillars matt black and wondering what would be the besst method?

Plastic primer then matt black?

Ordinary primer then matt black?

Or can i get away with just spraying matt black?

Also has anyone had a go at spraying the grab handles on the headlining black?

Thanks

[Matt]

Normal paint will chip and crack iirc, you. Need a special paint that's flexible

[Curt]

Normal primer has a tendency to flake. A good key, plastic primer and matt black would be fine.

[Bananalad]

Thanks.. Don't know whether to spray the handles or not...

[Matt]

I've seen handles done before, just don't know about a and b trims as someone I know sprayed the dash etc and it all cracked and looked shit

[Bananalad]

I thought the handles would be most likely to crack as they would be getting handled most? Ill have a go anyway it will be a learning experience...

[Niall]

Good coat of plastic primer and some Matt black paint. Let it dry properly somewhere warm and jobs a goodun. I've done all of my roof plastics in Matt black and they look fine!

[Eeyore]

I've done my interior lights and grab handles in sea grey. Don't think I primered it but make sure you put lots of lacquer on.

[Niall]

Don't need to lacquer it really. Just make sure the plastic is nice and clean and you get a really good coat or two of primer on.

[Bananalad]

I have the plastic primer here so ill throw a good coat on anyway thanks niall and sam

[Fozzy]

I primed and sprayed my old cars pillars, never had any problems with paint flaking, as once they are on they dont get handled

[Bananalad]

Sprayed everything and it turned out perfect