Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
P0230?
#1
LI've just bought my 306 2 weeks ago was running fine but then the eml came on and went into limp had a look it came up with p0320 so cleared it and then it started too over run I was told fuel pressure regulator so cut the tip off thought it was sorted until last no began hard too start then it keeps cutting out when driving help?
#2
If it's over running it's almost certainly the fuel pressure reg. You may have bodged it by cutting the filter off but it could probably do with a proper cleaning or even replacing. How many miles has the car done?
#3
Very common problem, there's a fuelling problems guide in the guide section that will help you narrow down the issue.
306 HDi Deathtrap - 130bhp / 220lbft
...UPGRADING...



#4
(25-04-2018, 08:42 PM)JTaylor2005 Wrote: If it's over running it's almost certainly the fuel pressure reg. You may have bodged it by cutting the filter off but it could probably do with a proper cleaning or even replacing. How many miles has the car done?

95k on the clock I did blast it out with an airline once I cut the end off it ran nice for two days
#5
You can reliably test any changes by full-throttle accelerating up a hill from low revs (1500ish) in fourth or fifth. If its going to cut out due to fuel pressure discrepancies it'll do it then.
306 HDi Deathtrap - 130bhp / 220lbft
...UPGRADING...





Possibly Related Threads…
Thread Author Replies Views Last Post
  maf causing P0230? stage 2 Arron 11 5,814 23-05-2013, 06:41 AM
Last Post: Poodle

Forum Jump:


Users browsing this thread: 1 Guest(s)