Posts: 5,494
Threads: 202
Joined: Dec 2011
Reputation:
58
Location: Eastleigh
Car Model/Spec: S16 and HDi daily
02-03-2013, 03:29 PM
(This post was last modified: 23-04-2013, 04:45 PM by Jonny81191.)
Yeah there's too much crap in the garage. So I'll sell some to you lot so you can fill your garages and sheds with crap 
Rear estate lights with flyeyes on, haven't got a picture but look at my sig or in my project thread for some shots of them fitted. £20 plus post.
Low mileage estate shocks £10 plus post
HDi Airbox and MAF (probably broken) £5 plus post
HDi 266mm calipers, need a refurb £10 plus post
11mm Transit pump, condition unknown £15 plus post SOLD
Estate rear wiper motor, works fine £10 plus post
Empty HDi cat, just weld it in place £10 plus post
SOLD
XUD clutch, almost held my stage 2 map, but kept slipping. Would be fine on a stage 1, good condition. £25 plus post
SOLD
Ignition barrel and key £5 plus post
About 2 metres of 2" flex pipe. Brand new, I used about 20cm of it. £10 plus post
SOLD
Black masked angels. Not perfect condition, not all the bulbs are there, 2 bulb retaining clips are missing. £30 plus post. SOLD
K03 turbo, can include HDi manifold if needed. About 2mm shaft play, a little bit in and out too. But was boosting 20psi no problem. £20 plus post
HDi midbox £5 plus post
SOLD
Dash Trim, broken bits on the bottom but out of sight when fitted. A few scratches. £3 plus post.
Welding and fabrication projects undertaken, contact me for more information.
Posts: 14,208
Threads: 448
Joined: Dec 2011
Reputation:
51
Location: isle of wight
Car Model/Spec: Pov. Spec White '6
Prices and description you gayer!
![[Image: 20A1806D-891D-40FB-BD52-AD519177A607-734...391753.jpg]](http://i35.photobucket.com/albums/d196/mattbush/20A1806D-891D-40FB-BD52-AD519177A607-7340-0000058F46391753.jpg)
TEAM CONROD SHITTING RALLYE!
Posts: 5,494
Threads: 202
Joined: Dec 2011
Reputation:
58
Location: Eastleigh
Car Model/Spec: S16 and HDi daily
(02-03-2013, 03:36 PM)Matt Wrote: Prices and description you gayer!
Give me chance, had to update on my laptop cos my phone keyboard is too small 
Welding and fabrication projects undertaken, contact me for more information.
Posts: 14,208
Threads: 448
Joined: Dec 2011
Reputation:
51
Location: isle of wight
Car Model/Spec: Pov. Spec White '6
Too small? But you tiny? Surly any keyboard is huge too you?
TEAM CONROD SHITTING RALLYE!
Posts: 1,748
Threads: 41
Joined: Dec 2011
Reputation:
12
Location: Midlands
Car Model/Spec: Dtractor
How many miles xud clutch done?
Posts: 5,494
Threads: 202
Joined: Dec 2011
Reputation:
58
Location: Eastleigh
Car Model/Spec: S16 and HDi daily
Not 100% sure as it was fitted when I got the car. But about 5k since I bought it.
Welding and fabrication projects undertaken, contact me for more information.
Posts: 8,749
Threads: 208
Joined: Jan 2012
Reputation:
60
Location: Wiltshire
Car Model/Spec: ph2 Gti6 / ph4 HDI Estate
What phase are the lights?
![[Image: DSC_0190-Copy_zpsf093f84d.jpg]](http://i1038.photobucket.com/albums/a468/167gti8/DSC_0190-Copy_zpsf093f84d.jpg)
Member of 99% warning or your nothing club!
Posts: 5,494
Threads: 202
Joined: Dec 2011
Reputation:
58
Location: Eastleigh
Car Model/Spec: S16 and HDi daily
(02-03-2013, 07:00 PM)puglove Wrote: What phase are the lights?
2/3 mate.
Welding and fabrication projects undertaken, contact me for more information.
Posts: 8,749
Threads: 208
Joined: Jan 2012
Reputation:
60
Location: Wiltshire
Car Model/Spec: ph2 Gti6 / ph4 HDI Estate
aaww bummer, all about the ph1 these days
Member of 99% warning or your nothing club!
Posts: 5,494
Threads: 202
Joined: Dec 2011
Reputation:
58
Location: Eastleigh
Car Model/Spec: S16 and HDi daily
Phase 2 it, I'm sure Carl would swap front ends with you
Welding and fabrication projects undertaken, contact me for more information.
Posts: 8,749
Threads: 208
Joined: Jan 2012
Reputation:
60
Location: Wiltshire
Car Model/Spec: ph2 Gti6 / ph4 HDI Estate
(02-03-2013, 08:23 PM)Jonny81191 Wrote: Phase 2 it, I'm sure Carl would swap front ends with you
Already asked him that lol, iv got a bit of a soft spot for 5dr ph2 DT, but it wouldnt be fair, my front end is pretty tatty bar the front bumper
Member of 99% warning or your nothing club!
Posts: 5,494
Threads: 202
Joined: Dec 2011
Reputation:
58
Location: Eastleigh
Car Model/Spec: S16 and HDi daily
You haven't seen the state of his. Seriously I reckon he might go for it, he's in spain this week but I'll ask him when he gets back if you want?
Welding and fabrication projects undertaken, contact me for more information.
Posts: 10,864
Threads: 117
Joined: Dec 2011
Reputation:
119
Location: Southampton
Car Model/Spec: 306 HDi and friends
Mmmmm, want those lights...
Posts: 5,494
Threads: 202
Joined: Dec 2011
Reputation:
58
Location: Eastleigh
Car Model/Spec: S16 and HDi daily
(03-03-2013, 10:17 AM)Poodle Wrote: Mmmmm, want those lights...
I can hang onto them for the April meet if you want?
Welding and fabrication projects undertaken, contact me for more information.
Posts: 5,494
Threads: 202
Joined: Dec 2011
Reputation:
58
Location: Eastleigh
Car Model/Spec: S16 and HDi daily
Lights and pump prov. sold.
Welding and fabrication projects undertaken, contact me for more information.
Posts: 10,864
Threads: 117
Joined: Dec 2011
Reputation:
119
Location: Southampton
Car Model/Spec: 306 HDi and friends
Dammit, let me know if it falls through mate, want! Lol
Posts: 5,494
Threads: 202
Joined: Dec 2011
Reputation:
58
Location: Eastleigh
Car Model/Spec: S16 and HDi daily
(04-03-2013, 02:27 PM)Poodle Wrote: Dammit, let me know if it falls through mate, want! Lol
Will do, but can't really hang onto stuff otherwise it never sells
Welding and fabrication projects undertaken, contact me for more information.
Posts: 10,864
Threads: 117
Joined: Dec 2011
Reputation:
119
Location: Southampton
Car Model/Spec: 306 HDi and friends
Can send you the money now mate, just didn't have the chance to get on the forum before. 
Posts: 5,494
Threads: 202
Joined: Dec 2011
Reputation:
58
Location: Eastleigh
Car Model/Spec: S16 and HDi daily
(04-03-2013, 06:33 PM)Poodle Wrote: Can send you the money now mate, just didn't have the chance to get on the forum before. They're yours then, pm incoming
Welding and fabrication projects undertaken, contact me for more information.
Posts: 5,494
Threads: 202
Joined: Dec 2011
Reputation:
58
Location: Eastleigh
Car Model/Spec: S16 and HDi daily
Updated first post
Welding and fabrication projects undertaken, contact me for more information.
Posts: 5,494
Threads: 202
Joined: Dec 2011
Reputation:
58
Location: Eastleigh
Car Model/Spec: S16 and HDi daily
Bumpity bump..
Make me offers on stuff!
Welding and fabrication projects undertaken, contact me for more information.
Posts: 5,494
Threads: 202
Joined: Dec 2011
Reputation:
58
Location: Eastleigh
Car Model/Spec: S16 and HDi daily
Still got most of this, needs to go!
Welding and fabrication projects undertaken, contact me for more information.
Posts: 5,494
Threads: 202
Joined: Dec 2011
Reputation:
58
Location: Eastleigh
Car Model/Spec: S16 and HDi daily
First post updated, Make me offers guys I need money!
Welding and fabrication projects undertaken, contact me for more information.
|
![[Image: 22f2b6b2-758b-4c1c-96fb-6fa9c6059b13_zpsf306b56b.jpg]](http://i585.photobucket.com/albums/ss299/Ha11elujaz0rs/22f2b6b2-758b-4c1c-96fb-6fa9c6059b13_zpsf306b56b.jpg)
![[Image: DSC_0190-Copy_zpsf093f84d.jpg]](http://s1038.photobucket.com/user/167gti8/media/DSC_0190-Copy_zpsf093f84d.jpg.html)
