20-06-2017, 05:44 PM
Right hand swing arm finally off. The word for the shaft (and possibly the tube), I think, starts in 'f' & ends in 'd'. There wasn't really anything recognisable of the outer bearings, apart from a bit of the shell. I'll get the tube cleaned up anyway. I assume you then have to measure the internal diameter where the outer bearing sits to ensure the bearing will still have an interference fit all round?
Good news is the new beam has gone on. The caliper brackets fitted it fine as did everything else. I managed to find some of the spacers to fit the hubs, from Spanish eBay! Just a few more bits to fix back and then it can go for it's MoT.
If I need to get a replacement tube for the other beam is there anyone on here who supplies them?
Cheers
Good news is the new beam has gone on. The caliper brackets fitted it fine as did everything else. I managed to find some of the spacers to fit the hubs, from Spanish eBay! Just a few more bits to fix back and then it can go for it's MoT.
If I need to get a replacement tube for the other beam is there anyone on here who supplies them?
Cheers