Gasket mating surface

[D@wson]

Thanks for the replies so far people! Got loads more of today with some wd and 400 grit wet and dry.

Pics!




I dont have anything electric which is suitable (i looked at the angle grinder lol). Is there any chemicals I can buy from halfrauds that will get the last stubborn bits off? It is perfectly smooth but there are bits that are stuck in the casting bits which I cant get off

I'm prepared for: "Take a big dose of MTFU and get on with it" lol.

Nice looking good,

Take a big dose of MTFU and get on with it