25-06-2012, 09:05 AM
Yo! Had this posted in my project thread but think it might get seen more here!
The clutch pedal is currently sitting in the down position but has about an inch more to go down where it feels the same as normal. I can then pull the pedal up with my hand but as soon as its pressed it goes straight to the floor again.
I looked at the arm position when it was pressed down... and then once i had pulled it up and the arm was always at 3 o'clock...
pedal down
![[Image: IMG_20120624_210533.jpg]](http://i1184.photobucket.com/albums/z327/srowell3/IMG_20120624_210533.jpg)
pedal up
No difference!
so im thinking it might be something to do with the auto rachet/adjustment mechanism? ie its not shortening the cable enough? Tried to move the arm manually and could move it back to about 4 o'clock but that was as far as it would go.
Thoughts?
Thanks in advance!
The clutch pedal is currently sitting in the down position but has about an inch more to go down where it feels the same as normal. I can then pull the pedal up with my hand but as soon as its pressed it goes straight to the floor again.
I looked at the arm position when it was pressed down... and then once i had pulled it up and the arm was always at 3 o'clock...
pedal down
pedal up
No difference!
so im thinking it might be something to do with the auto rachet/adjustment mechanism? ie its not shortening the cable enough? Tried to move the arm manually and could move it back to about 4 o'clock but that was as far as it would go.
Thoughts?
Thanks in advance!