Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
lowering
#4
(23-06-2012, 11:07 AM)KrisB Wrote: Darrenjlobb can do it but i think he does it the Notch way instead of fully removing the bars and doing it the long (propper way) I can do it but i'm bit of a trek from you.


Why do you need to remove the bars? Iv never done that? Only ever pulled them about 3inches to get them out of the spline each end Confused

[Image: DSC_0190-Copy_zpsf093f84d.jpg]
Member of 99% warning or your nothing club!

Reply
Thanks given by:


Messages In This Thread
lowering - by simonx3 - 22-06-2012, 09:57 PM
RE: lowering - by KrisB - 23-06-2012, 11:07 AM
RE: lowering - by puglove - 23-06-2012, 02:55 PM
RE: lowering - by Niall - 23-06-2012, 11:11 AM
RE: lowering - by simonx3 - 23-06-2012, 03:00 PM
RE: lowering - by Kezzieboy - 23-06-2012, 04:05 PM
RE: lowering - by simonx3 - 23-06-2012, 04:19 PM
RE: lowering - by puglove - 23-06-2012, 04:25 PM
RE: lowering - by darrenjlobb - 11-07-2012, 10:23 PM
RE: lowering - by simonx3 - 11-07-2012, 10:25 PM
RE: lowering - by darrenjlobb - 12-07-2012, 06:26 AM
RE: lowering - by cwspellowe - 12-07-2012, 06:44 AM

Forum Jump:


Users browsing this thread: 1 Guest(s)